Roland makes no warranty, either expressed or implied, with respect to any of the software, including, without limitation, any implied warranties of merchantability or fitness for a particular purpose.

High strength hot finished hollow sections suitable for all construction and mechanical applications. Celsius® 420 is suitable for all internal and external applications to BS5950-1:2000, EN1993 and BS5400. Grade 420-12 is a spheroidal graphite iron that possesses strength, impact and ductile characteristics of a different type to grey cast iron grades, though with similar machining characteristics. Grade 420-12 is suitable for applications where the optimal impact, fatigue, electrical conductivity and magnetic permeability features of a spheroidal graphite iron (SG iron) is required. Typical applications include valves, dies, pistons and moulds. About Cast Iron Grades 400/15–420/12 Round BarCelsius® hollow sections EN10210:S355NH are subject to specific inspection and testing and are supplied with an inspection certificate type 3.1 to EN10204. b) The OSS, etc. in the case of the preceding paragraph shall be subject to the OSS, etc. license (herein referred to as "OSS License"), and you shall comply with the OSS License.

Grade 420 stainless steels are welded using welding rods, coated with grade 420 metals, to achieve high-strength joints. During the process, steels are pre-heated at 150 to 320°C and post-heated to 610 to 760°C. In the “as welded” condition, parts are welded using grade 309 filler rods to achieve ductile joints. However, grade 309 electrodes or rods are recommended for welding grade 420 steels by AS 1554.6. MachiningNormalized fine grain steel, so free of internal stresses and with a minimum strength of 460N/mm 2 allowing the highest fabrication factors and enabling material cost savings and lighter structures Roland grants you the following non-exclusive rights to use the SOFTWARE in accordance with the terms of this License Agreement. Chemical Test (%): C = 0.01, Mn = 0.4, Ni = 4.2 rest is same as per manufacturer test report. and quite acceptable. c) If this SOFTWARE contains multiple templates of media (such as floppy disks and CD-ROM) and these media contain the same software, you may use only the one form of media that is appropriate for your computer. You shall not use the remaining form(s) of media on another computer.